User manual

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
175
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Number of paper feeding retries
(page 188)
Configure this setting to change the number of
feeding retries when a pick error occurs.
This setting can also be configured in the
operator panel.
1 to 12 times 3 times
Cleaning Cycle
(page 181)
Specify the scanner cleaning cycle.
Select whether or not to display the cleaning
instruction message from the scanner driver.
1,000 to 255,000 sheets
(in increments of 1,000)
Show cleaning instructions:
Selected/Not selected
5,000 sheets
Not selected
Life Counter Alarm Setting
(page 181)
Specify the replacement cycle for the
consumables.
Pick Rollers / Brake Rollers:
10,000 to 2,550,000 sheets
(in increments of 10,000)
Pick Rollers:
200,000 sheets
Brake Rollers:
200,000 sheets
Vertical Streak Detection
(page 204)
Select whether to enable or disable vertical
streak detection.
Enable to detect vertical streaks (dirt on the
glass) when you perform scanning with the
ADF.
This setting can also be configured in the
operator panel.
Enable / Disable Disable
Vertical Streak Sensitivity
(page 205)
Specify the sensitivity level to detect vertical
streaks (dirt on the glass) when vertical streak
detection is enabled.
This setting can also be configured in the
operator panel.
Low / Normal / High Normal
Pick Speed
(page 188)
When you experience frequent multifeeds and
paper jams, the symptom may be improved by
slowing down the speed in which documents
are picked (fed).
This setting can also be configured in the
operator panel.
Normal / Slow Normal
AutoCrop Boundary
(page 189)
Specify whether or not to optimize (round up/
down) the fractional part of the scanned image
data.
Optimize / Round Down Optimize
Item Description Parameter/Value Factory Default