User manual

Appendix
Chapter 8 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
132
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
■Transport lock, cover open, and print errors
Error codes beginning with the letter "U" are displayed.
J2:55 Multifeed detected
(Overlap)
Press the Scan button to
eject the document.
After ejecting the
document, multifeed
detection for the next
document can be
enabled/disabled from
the Menu button.
1 Press the [Scan/Enter] button on
the operator panel to eject the
documents.
2 Press the [Menu] button on the
operator panel, select whether or
not to detect multifeed, and then
press the [Scan/Enter] button or
perform a scan from the
computer.
Multifeed detected
(Overlap)
Press the Scan button to
eject the document.
Press the Menu button to
memorize the multifeed
pattern.
1 Press the [Scan/Enter] button on
the operator panel to eject the
documents.
2 Press the [Menu] button on the
operator panel, select whether or
not to memorize the pattern, and
then press the [Scan/Enter]
button or perform a scan from the
computer.
Multifeed detected
(Overlap)
Press the Scan button to
eject the document.
1 Press the [Scan/Enter] button on
the operator panel to eject the
documents.
2 Press the [Scan/Enter] button on
the operator panel or perform a
scan from the computer.
J2:56 Multifeed detected
(Length)
Press the Scan button to
eject the document.
1 Press the [Scan/Enter] button on
the operator panel to eject the
documents.
2 Press the [Scan/Enter] button on
the operator panel or perform a
scan from the computer.
Error
code
Error messages Resolution
J8:01 Sensor(s) dirty
Clean the Pick Sensor.
Open the ADF and clean the eight
document sensors.
For details, refer to "Chapter 6
Daily Care" (page 108).
J8:04 Sensor(s) dirty
Clean the READ-TOP
Sensor.
Error
code
Error messages Resolution
U0:10 Transport lock
error
Unlock the
transport lock
switch.
(fi-7260/fi-7280)
Unlock the transport lock switch.
For details, refer to "Installing the
Scanner" in Getting Started.
U4:40
(*1)
ADF open Close the ADF and reload the
documents.
U5:4A
(*2)
Imprinter Cover
Open
(only when
imprinter is
installed)
Close the print section of the imprinter,
and load the document again.
U6:B4 Print cartridge not
installed
Check if the Print
Cartridge is
mounted
correctly.
(only when
imprinter is
installed)
This error is related to the imprinter.
For details, refer to the fi-718PR
Imprinter Operator's Guide.
Error
code
Error messages Resolution