User manual

Chapter 6 Daily Care
Appendix
Glossary
Introduction
Index
Contents
TOP
116
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Daily Care
Operational
Settings
6 When you press the [Scan/Enter] button, the feed/eject rollers
rotate a certain amount.
7 Put a piece of cloth moistened with Cleaner F1 or a sheet of
Cleaning Wipe against the roller surface, and wipe horizontally.
Wipe off any dirt or dust on the surface by pressing the [Scan/
Enter] button to rotate the rollers.
Make sure that it is wiped properly because black residue on the
roller will affect the feeding performance.
As a guideline, pressing the [Scan/Enter] button seven times will
rotate the feed/eject rollers one revolution.
4 Close the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 27).
5 Reset the cleaning counter.
Reset the counter by performing one of the following actions:
z Reset the counter in [4: Consumable counters] on the [Settings
Menu] screen of the operator panel.
For details, refer to "4.2 Settings Menu" (page 66).
z Reset the counter in the Software Operation Panel.
For details, refer to "Resetting the sheet counters" (page 179).
When you press the [Scan/Enter] button,
the feed/eject rollers rotate at the same
time. Be careful not to touch the rollers with
your hand while they are rotating.
Menu
Scan/Enter
Check
Power
Stop/Clear
[Scan/Enter] button
Be careful not to have your fingers caught
when closing the ADF.
ATTENTION
Confirm that the ADF is closed properly. Otherwise, the document
may not be fed into the ADF.