User manual

Chapter 6 Daily Care
Appendix
Glossary
Introduction
Index
Contents
TOP
114
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Daily Care
Operational
Settings
3 Clean the following locations with a cloth moistened with
Cleaner F1 or a sheet of Cleaning Wipe.
Brake roller (× 2)
Remove the roller from the scanner.
For details about removing the brake roller, refer to "7.2 Replacing the
Brake Roller" (page 121).
Gently wipe off any dirt or dust along the grooves, taking care not to
damage the roller surface.
Pick roller (× 2)
Gently wipe off any dirt or dust along the grooves as you rotate the roller
manually, taking care not to damage the roller surface. Make sure that it
is wiped properly because black residue on the roller will affect the
feeding performance.
Plastic idler roller (× 2)
Gently wipe off any dirt or dust on the surface of the rollers. Make sure
that it is wiped properly because black residue on the roller will affect the
feeding performance.
Rubber idler roller (× 2)
Gently wipe off any dirt or dust on the surface of the rollers. Make sure
that it is wiped properly because black residue on the roller will affect the
feeding performance. When wiping, be careful not to damage the
sponge that is attached to the middle of the rubber idler roller.
Glass (× 2)
Gently wipe the dirt and dust off the surface of the glass sections.
Glass (× 2)
Pick roller
(× 2)
Ultrasonic sensor (× 2)
Plastic idler
roller (× 2)
Feed roller (× 2)
Eject roller
(× 2)
Brake roller (× 2)
Document
sensor
(× 8)
Rubber idler
roller (
× 2)
ATTENTION
Vertical streaks may appear on the scanned image when the glass is
dirty.