User manual

Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
57
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
Configuring the
Scan Settings
How to Use the
Operator Panel
2 Start up ScandAll PRO and click the [Scan] menu J
[Scanner Setting].
D The [TWAIN Driver (32)] dialog box appears.
3 Select [Double-page spread] for [Scan Type].
4 Click the [Carrier Sheet] tab and configure settings such
as [Image Mode].
5 Click the [OK] button.
D The settings are saved.
6 Scan the document by clicking the [Scan] menu J [Scan]
in ScandAll PRO.
D The images on the front and back are merged into a single image.
z Place the end with the black and white pattern as the
leading edge in the direction of the arrow.
z Set the back side of the document (right-hand side of a
double-page spread) facing towards you.
z Adjust the side guides to the width of the Carrier Sheet
to avoid skewing.
If the [TWAIN Driver (32)] dialog box does not appear,
check the setting in ScandAll PRO by clicking the [Tool]
menu J
[Preferences] to open the [Setup] dialog box,
then confirm that [TWAIN] is selected for [Device Driver]
in the [Scan] tab.