User manual

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
26
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section explains about the bundled "ScandAll PRO"
image scanning application, which is used as an example to
explain the procedures in this manual.
ScandAll PRO supports both TWAIN and ISIS drivers. By
defining scan settings as profiles, you can customize the
settings according to your preference.
When ScandAll PRO is installed, you can also install
"ScandAll PRO ScanSnap mode Add-in". This is an add-in
application which provides a different set of driver settings as
an alternative to using ScandAll PRO. TWAIN driver is
required to use this application. Using the ScanSnap mode
enables easy scanning with a single button.
"Chapter 5 Various Ways to Scan" (page 52) explains how to
scan different types of documents by using examples of the
TWAIN driver started via ScandAll PRO.
For more details about ScandAll PRO, refer to "ScandAll PRO
User's Guide".
For details about ScandAll PRO ScanSnap mode Add-in, refer
to the ScandAll PRO ScanSnap mode Add-in User's Guide.
1.9 Image Scanning Application
You cannot use ScandAll PRO ScanSnap mode Add-in in the
following cases:
z When the scanner is connected to fi-5000N
z When the scanner is connected with a SCSI cable