User manual

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
22
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Power saving mode keeps the power consumption low when
the scanner has not been used for a certain period of time.
If the scanner is left powered on for 15 minutes without being
used, it automatically enters power saving mode.
When it enters power saving mode, the Function Number
Display on the operator panel switches off but the [Power]
button remains lit in green.
To resume from power saving mode, perform one of the
following:
z Load a document in the ADF paper chute
z Press any button on the operator panel
* Note that pressing the [Power] button for more than two seconds will
turn the power off.
z Perform scanning from the scanner driver
Also, the scanner can be set to turn itself off automatically
when it is turned on and left unused for a certain period of
time.
You can save the power consumption by having the scanner
turn off automatically.
To enable this setting, select the [Power off after a certain
period of time] check box in [Device Setting] of the Software
Operation Panel. For details, refer to " Waiting Time to Enter
Power Saving Mode [Power saving]" (page 154).
To turn the scanner back on when it is automatically turned off,
press the power button on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
18).
1.7 Resuming from Power Saving Mode
z Depending on the application you are using, the scanner
may not be turned off automatically even when the [Power
off after a certain period of time] check box is selected.
z If the scanner turns itself off automatically while you are
using an image scanning application, close the application
first, then turn the scanner back on.
The waiting time for entering power saving mode can be
changed in the Software Operation Panel.
For details, refer to "Waiting Time to Enter Power Saving Mode
[Power saving]" (page 154).