User manual

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
154
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Waiting Time to Enter Power Saving Mode
[Power saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 128).
2 From the listing on the left, select [Device Setting].
3 Use the slide bar to specify the waiting time before
entering power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
9.7 Settings Related to Waiting Time
When you select the [Power off after a certain period of
time] check box, the scanner will turn itself off
automatically if it is turned on and left unused for the set
time.
The time until power-off can be selected from 1/2/4/8
hours.