user manual

Chapter 3 Web Operation
IP-900 Series
45
Table 3-11 Alarm List
Code Name Description Details (The part after the * mark is not displayed.)
I001 SDI input down HD/SD-SDI input signal not detected −
I002 HDMI input down HDMI input signal not detected −
I003 Analog input down Analog video input signal not detected −
I011 Video synchronization error Video input synchronization failure −
I021 Input data error (*7) Count-up occurred in the performance
statistics error counter
#xxxxxxxxxxxxxxxx
* 64-bit hexadecimal number. For the meaning of
each bit, see Table 3-12, "Bit Formats for Input Data
Errors."
E001 Power error (*1) Power failure occurred
#1 * Power failure on CNT board
#2 * Power failure on COD board
E003 Temperature error occurrence (*5) Extreme temperature (shutdown
processing started)
#1 TEMP1=t1 TEMP2=t2 FAN=xxxRPS
#2 TEMP1=t1 TEMP2=t2 FAN=xxxRPS
* Details are as follows:
#1/#2: Number of the temperature sensor that has
detected a temperature error
t1: Temperature indicated by temperature sensor 1
t2: Temperature indicated by temperature sensor 2
xxx: FAN rotational speed
E004 Flash ROM error (*1) Internal flash ROM access error occurred
/dev/mtd0 to 15
* Displays the occurrence range of access error.
E00A Flash ROM check sum error (*1) Operation data error detected in internal
Flash ROM
software
bundle software
configuration
configuration#1∼#10
option
* Displays the occurrence range of check sum errors.
E010 FAN error (*2) FAN error (low speed) or stopped xxxRPS * xxx: FAN rotational speed