Datasheet

Index
C141-C008 IN-11
service parameter response page............. 1-53
SES sense code...................................... 1-104
SET DEVICE IDENTIFIER (A4)......... 4-134
SET DEVICE IDENTIFIER
parameter list.................................... 4-135
SET LIMITS (33).................................. 4-144
SET LIMITS command......................... 4-145
setting parameter by MODE
SELECT command .............................. 6-7
SFF8045 .................................................. 1-99
SFF8067 .................................................. 1-99
short enclosure status ............................ 4-185
signal function in SFF8045 mode ........... 1-17
signal function in SFF8067 mode ........... 1-23
signal interchange on FC loop................. 2-10
single command ........................................ 2-8
SIZE ........................................................4-49
size enable ............................................... 4-49
SKSV......................................................... 5-4
SMART data page (X'38')..................... 4-117
SMART status page (X'2F') .................. 4-117
soft sectoring ........................................... 4-41
soft write protect .....................................4-56
spare sector area ........................................ 6-2
spare sector within cell.............................. 6-2
specified cycle count over device
lifetime ............................................. 4-112
specifying address format ..................... 4-175
specifying initialization method............ 4-150
specifying range where access
permitted .......................................... 4-145
SSEC ....................................................... 4-41
standard INQUIRY data.....................4-3, 4-4
start specification .................................... 4-81
START/STOP UNIT (1B)....................... 4-80
START/STOP UNIT command.............. 2-24
start_1...................................................... 1-18
start_2...................................................... 1-18
starting boundary..................................... 4-59
start-stop cycle counter ......................... 4-113
start-stop cycle counter page (X'0E') .... 4-111
status.......................................................... 2-6
status byte.................................................. 2-6
stop format ............................................ 4-153
stop specification..................................... 4-81
STPF...................................................... 4-153
superseding reserve..................................4-83
support ........................................... 4-10, 4-11
support log page (X'00')...........................4-96
supported function.....................................4-6
SURF .......................................................4-42
surface addressing....................................4-42
SWP.........................................................4-56
SYNCHRONIZE CACHE (35).............4-147
T
tagged queuing.........................................2-17
target certification list............................4-149
TARGET RESET .......................... 2-26, 2-27
TARGET RESET sequence,
outline of.............................................2-27
target save disable....................................4-93
TASK FULL status..................................5-15
TASK SET FULL status............................2-7
task set type .............................................4-54
TB ............................................................4-27
temperature............................................4-110
temperature page (X'0D').......................4-109
termination status analysis.......................5-14
TEST........................................................4-60
TEST UNIT READY (00).........................4-1
third party process logout ........................1-64
third party release function......................4-86
third party reserve function .....................4-84
threshold met criteria...............................4-93
TMC.........................................................4-93
topologies in fibre channel interface .........1-2
total read byte processed .......................4-104
total read error posted............................4-103
total recoverable read error posted
to INIT..............................................4-104
total recoverable verify error posted
to INIT..............................................4-107
total recoverable write error posted
to INIT..............................................4-100
total unrecoverable read error
posted to INIT...................................4-105
total unrecoverable verify error
posted to INIT...................................4-108
total unrecoverable write error
posted to INIT...................................4-101
total verify byte processed.....................4-108