Datasheet

Index
IN-2 C141-C008
BC..............................................................1-4
bit 0............................................................2-6
bit 1............................................................2-5
bit 2............................................................2-5
bit 3............................................................2-5
bit 4............................................................2-5
bit 5............................................................2-5
bit 6............................................................2-5
bit 7............................................................2-5
block descriptor ...................... 4-22, 4-76, 6-4
block descriptor length ...................4-22, 4-76
buffer data (mode = 000, 001)...............4-188
buffer data (mode = 0000, 0001)...........4-194
buffer descriptor ....................................4-196
buffer empty ratio.............................3-7, 4-35
buffer full ratio .................................3-6, 4-35
buffer overrun/underrun page
(X'01').................................................4-97
buffer-to-buffer frame transfer..................1-5
burst size during initial connection .........4-37
bus inactivity limit...................................4-36
BUSY status ..............................................2-7
byte 2 ..............................................4-22, 4-93
byte 6 to 16 ..............................................4-44
byte distance from index format
defect descriptor ...............................4-154
byte/bit alignment..................................1-103
byte/bit alignment in ESI.......................1-103
C
C list................................................4-149, 6-1
cache control parameter...........................3-11
cache segment count................................4-51
cached command .......................................3-8
cached data ................................................3-8
caching operation.......................................3-8
caching parameter................... 3-10, 4-47, 6-7
caution in specifying D list....................4-156
CDB operation code ................................5-13
CDB size..................................................4-11
CDB specification .....................................6-5
CDB usage data .......................................4-11
changing reserve condition......................4-83
characteristics of fault LED out
signal ..................................................1-17
charge.......................................................1-17
charge supply to drive..............................1-17
CHECK CONDITION status.....................2-7
class 3 service parameter .........................1-46
CLEAR TASK SET....................... 2-26, 2-27
clocking field .............................................4-9
CmdDt........................................................4-3
combination of error recovery flag..........4-30
combination of SOF and EOF..................2-11
combinations of RdInh and WrInh ........4-145
COMMAND byte definition..................1-102
command cleared by another INIT..........2-20
command code ...........................................2-4
command completion wait time-out........5-15
command descriptor block.......................1-85
command executable even in not
ready state ...........................................2-24
command execution .................................2-12
command format........................................2-1
command inherent information..................5-4
command link ..........................................2-15
command other than INQUIRY and
REQUEST SENSE ............................. 2-20
COMMAND phase ................................1-102
command processing..................................2-1
command processing exception...............2-21
command processing in not ready
state.....................................................2-23
command queuing function .....................2-16
command specification ..............................4-1
command support data.............................4-10
command supported data ...........................4-3
COMMAND TERMINATED status .........2-7
command transfer ....................................1-30
COMMAND, WRITE phase..................1-102
common service parameter......................1-44
communication between initiator
and target ............................................1-29
comparison of definition between
FC and SCSI .......................................2-26
CONDITION MET status..........................2-7
connect time limit ....................................4-36
control byte ................................................2-5
control command .......................................4-1
control field..............................................1-82
control mode parameter ...........................4-53