Datasheet

Command Specifications
4-64 C141-C008
a. DTOLI (disable target originated loop initialization)
This bit is possible to specify and operates according to the specification.
This bit specifies concerning LIP.
"1": − An Initializing LIP is not issued when the IDD enters the loop.
− If the Initializing LIP is received, operation corresponds to the
Initialization LIP.
− When a Loop Failure is detected, the Loop Failure LIP [LIP (F8, x)]
is issued.
− When clearing a Loop Failure, the Initializing LIP [LIP (F7, x)] is
issued.
"0": − An Initializing LIP is issued when the IDD enters the Loop.
b. DTIPE (disable target initiated port enable)
This bit is possible to specify and operates according to the specification.
This bit specifies concerning Port Enable.
"1": Before the IDD enters the Loop, it has the Loop Port Enable Primitive
from the INIT. It uses the hard address, which is usable by a SCA
connector or a device address jumper.
"0": The IDD does not have the Loop Port Enable primitive, so it enters the
loop port.
c. ALWLI (allow login without loop initialization)
This bit is possible to specify and operates according to the specification.
This bit specifies concerning Loop Initialization.
"1": The IDD uses the hard address, which is usable by a SCA connector or a
device address jumper, and in loop initialization, it makes the address to
respond to login without confirming it. (Loop Initialization is not
performed.)
"0": The IDD carries out confirmation of the address in the Loop
Initialization process.