Datasheet

Command Specifications
4-6 C141-C008
e. Response data format field
This field shows the code which shows the standard INQUIRY data
format. The definition of the code is (0,0,0,1) for SCSI-1/CCS mode or
(0,0,1,0) for SCSI-2 or SCSI-3 mode.
f. Additional data length
This field shows the length of the INQUIRY data (byte length) after byte 5.
This value shows the length in the INQUIRY data held by the IDD without
relation to the specification in the transfer byte length field in the CDB, and
is always X‘5B’ (total data length = 96 bytes).
g. Supported functions
The bit positions shown below are valid only when the CHANGE
DEFINITION command is set so that the SCSI-2 or SCSI-3 mode
INQUIRY data are transferred, and the functions which the IDD supports
are shown in the bit correspondence.
"1" indicates that that function is supported and "0" indicates that that
function is not supported. When the CHANGE DEFINITION command
is not set so that SCSI-2 mode INQUIRY data are transferred, "0" is
displayed in all these bit positions.
− SCSI-3 mode
[Byte 3]
− AERC (Asynchronous event reporting capability):
Asynchronous condition notify function [0]
− NORMACA (Normal ACA supported):
ACA support [0]
− HISUP (Hierarchical support):
Defined the hierarchical addressing model to assign LUN [0]
[Byte 5]
− SCCS (SCC support):
Embedded storage array controller equipment [0]
[Byte 6]
− BQue (Basic queuing):
Combination with CMDQUE [0]
− EncServ (Enclosure service):
Enclosure service [1]
− MultiP (Multi port):
Supported multi-port [1]