Datasheet

Fibre Channel Interface
1-88 C141-C008
(6) SEQ_ID.. (Sequence Identifier)
− The drive responds FFh.
(7) DF_CTL.. (Data Field Control)
Set 00h because no optional header is used.
(8) SEQ_CNT.. (Sequence Count)
− It is responded 0000h because it is used single frame sequence.
(9) OX_ID.. (Originator Exchange Identifier)
− The drive responds the OX_ID of FCP CMND received from the
initiator.
(10) RX_ID.. (Responder Identifier)
Set FFFFh to indicate that RX_ID is unused.
(11) Parameter
Unused the parameter in the FCP XFER RDY and 00000000h entered.
The payload field of the FCP XFER RDY is defined below.
Word xx and byte y of the payload are represented by [PL:Wxx/By].
(1) Data Relative Offset (Data_R0) [PL:W00]
For this FCP XFER RDY frame, The drive specifies the byte Offset value of
the first WT data sending the initiator.
The initiator describes the value of this field in the Relative Offset of the first
WT data for this FCP XFER RDY frame.
(2) Burst Length (BURST_LEN) [PL:W01]
The initiator can be transferred number of WT Data Byte for this FCP XFER
RDY frame. The BURST_LEN is satisfied with the following the conditions.
BURST_LEN:
(WT Command to transfer data rest of byte velocity)
BURST_LEN:
(Maximum Burst Size of Disconnect/Reconnect SCSI mode page)
BURST_LEN:
(Available transferring maximum byte velocity in FC Sequence)