Server User Manual

Note -

For a building block configuration, press the power switch on the master chassis. The

power switches of the other chassis are disabled.

Note -

For a building block configuration, check the POWER LEDs on all the chassis that

make up the system.

Check that the POWER LED on the operation panel is off.

5.5 Accessing Components

This section describes the operations that must be completed prior to accessing a

component requiring maintenance.

5.5.1 Lowering the cable support

For a component that is accessed from the rear of the SPARC M10-4/M10-4S, the

cable support must be lowered and then the cables removed.

Loosen the right and left screws fixing the cable support, and unlock it by

pulling the upper and lower metal fittings towards you (in the direction of the

arrow).

Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual

･

December 201364