Server User Manual

Note -
For a building block configuration, switch the mode switches of the master chassis
and those chassis whose XSCFs are in the standby state.
XSCF>
poweroff -a
PPAR-IDs to power off:00 ,01
Continue? [y|n] :
y
00 : Powering off
01 : Powering off
Note -
For a building block configuration, check the POWER LEDs on all the chassis that
make up the system.
Note -
For a building block configuration, switch the mode switches of the master chassis
and those chassis whose XSCFs are in the standby state.
5.4.1 Stopping the system with the XSCF command
1.
Switch the mode switch on the operation panel to Service mode.
For details, see "2.2.2 Control function of the operation panel."
2.
LogintotheXSCFshell.
3.
Execute the poweroff command.
In response to the confirmation message, enter "y".
In the following example, the status of PPAR-IDs 00 and 01 displays "Powering
off", which indicates that the power to the physical partitions is being turned off.
The following processes are performed.
- Oracle Solaris is completely shut down.
- The system stops and enters the POWERON READY state (The XSCF is running).
For details, see "6.2.2 Stopping the whole system" in the Fujitsu M10/SPARC M10
Systems System Operation and Administration Guide.
4.
Check that the POWER LED on the operation panel is off.
5.4.2 Stopping the system from the operation panel
1.
Switch the mode switch on the operation panel to Service mode.
For details, see "2.2.2 Control function of the operation panel."
2.
Press the power switch on the operation panel for 4 seconds or more.
For details, see "2.2.2 Control function of the operation panel."
Chapter 5 Understanding the Prep arations for Enabling Maintenance 63