Server User Manual

Note -
When there is no free space on a physical partition or when all the resources are
assigned to the control domain, DR cannot be applied to the physical partition.
XSCF>
switchscf -t Standby
The XSCF unit switch between the Master and Standby states.
Continue? [y|n] :
y
XSCF>
showpparstatus -p 0
PPAR-ID PPAR Status
00 Running
XSCF>
showdomainstatus -p 0
Logical Domain Name Status
primary Solaris running
guest0 Solaris running
guest1 Solaris running
domain01 Solaris running
5.2 Releasing a Chassis from the Physical
Partition
This section describes the procedure for releasing a chassis requiring maintenance
from the physical partition by using dynamic reconfiguration (DR). DR can be used
only for a building block configuration.
1.
Log in to the XSCF shell.
2.
When the chassis requiring maintenance is operating as the master chassis,
execute the switchscf command to switch the master XSCF to a standby
XSCF.
In response to the confirmation message, enter "y".
When the chassis requiring maintenance is a slave XSCF, proceed to step 4.
3.
Log in to the XSCF again.
4.
Execute the showpparstatus command to confirm the operating condition of
the physical partition.
In the following example, [Status] of PPAR-ID 00 displays "Running", which
indicates that the physical partition is operating.
5.
Execute the showdomainstatus command to confirm the operating condition
of the logical domain.
In the following example, [Status] of the logical domain displays "Solaris
running", which indicates that Oracle Solaris is operating.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
December 201356