Server User Manual

#
ldm list-bindings rootdom
------------------------
Ommitted
------------------------
VSW
NAME MAC NET-DEV ID DEVICE LINKPROP
DEFAULT-VLAN-ID PVID ......
vsw0 xx:xx:xx:xx:xx:xx net4
(*1)
0 switch@0 1
1
PEER MAC PVI D VID
MTU MAXBW .. ...
vnet0@guest1
(*2)
xx:xx:xx:xx:xx:xx 1
1500
------------------------
Ommitted
-----------------------
#
dladm show-phys -L
LINK DEVICE LOC
net0 igb0 /BB0/CMUL
net1 igb1 /BB0/CMUL
net2 igb2 /BB0/CMUU
net3 igb3 /BB0/CMUU
net4 ixgbe0 BB#0-PCI#0 <--
*
net5 ixgbe1 BB#0-PCI#0
2.
Connect to the control domain console of the physical partition.
3.
Check whether there is any guest domain that is virtually using the PCIe card
requiring maintenance.
- For Ethernet card
a.
Execute the ldm list-bindings <domain name> command from the control
domain to check virtual network switch [VSW] information for the physical
network interface name ([NET-DEV] value) that is assigned to a virtual
network switch.
In the following example, "rootdom", the logical domain name to which the
PCIe card is assigned, is specified.
*1: Physical network interface
*2: Virtual network device and guest domain serviced by vsw0
b.
Log in to the logical domain to which the PCIe card is assigned. Then,
determine the physical location of the physical network interface above,
and check whether it corresponds to the PCIe card requiring maintenance.
- For Oracle Solaris 11, execute the dladm show-phys -L command to determine
[LOC] (physical location) of the physical network interface corresponding to
[NET-DEV] in step a.
- For Oracle Solaris 10, execute the /etc/path_to_inst command to confirm the
physical device path, and compare it with the physical device path displayed
by the ldm list-io -l command to determine the physical location.
Chapter 13 Maintaining the PCI Express Cards 247