Server User Manual

A
2.
Loosen the two screws holding the upper rear side of the CPU memory unit
lower. Then, remove the rear cover (A in the figure) by pulling it in the
direction of the arrow.
Figure 7-22
Removing the rear cover
3.
Remove the XSCF board.
-
For the SPARC M10-4 with a FRAME-A CPU memory unit
Remove the three screws fixing the XSCF board (A in the figure) and rear
cover. Tilt the right lever of the XSCF mount with your fingers about 5 mm (0.2
in.) to the right (B in the figure). Lift up the right side of the XSCF board and
release the connection of the connector (C in the figure).
Fujitsu M10-4/Fujitsu M10-4S/SPARC M 10-4/SPARC M10-4S Service Manual
･
December 2013106