User manual
Table Of Contents
- Declarations of conformity
- Fujitsu Contact Information
- Ports and controls
- Important notes
- First-time setup of your device
- Working with the notebook
- Status indicators
- Switching the notebook on
- Switching the notebook off
- Keyboard
- Touchpad and touchpad buttons
- Touchscreen/LCD screen without touch function (device-dependent)
- Webcam
- Rechargeable battery
- Using the energy saving functions
- Memory cards
- Speaker and microphones
- Wireless€LAN/Bluetooth wireless components
- Ethernet and LAN
- Your USB Type-C dock (optional)
- Security functions
- Connecting external devices
- Removing and installing components during servicing
- Settings in BIOS Setup Utility
- Starting the BIOS Setup Utility
- BIOS Setup Utility operation
- Exiting BIOS Setup Utility
- Exit Saving Changes - save changes and exit BIOS Setup Utility
- Exit Discarding Changes - Reject changes and exit BIOS Setup Utility
- Load Setup Defaults – load default values
- Discard Changes - Discard Changes without exiting BIOS Setup Utility
- Save Changes - save changes without exiting the BIOS Setup Utility
- Save changes and power off
- Troubleshooting and tips
- Help if problems occur
- Reset by switching the battery off
- If you need to restore your system
- The notebook's date or time is incorrect
- When certain characters are entered on the keyboard, only numerals are written
- The notebook’s LCD screen remains blank
- The LCD screen of the notebook is difficult to read
- The external monitor remains blank
- The external monitor is blank or the image is unstable
- The notebook does not start after switching it on
- The notebook stops working
- The printer does not print
- The wireless connection to a network does not work
- Smart Card reader is not recognized
- Smart Card PIN forgotten
- Smart Card lost
- Error messages on the screen
- Technical data
- Manufacturer’s notes
- Appendix
Appendix
**
*
* = An optional hub for a wire d LAN may
be required depending upon the type
of access point used.
** = ADSL mode m, cable modem, or s imilar
How to Handle This Device
The WLAN device is an optional device that may come pre-installed in your mobile compu ter. Under
normal circumstances, it should not be necessary for you to remove or re-install it. The Operating
System that your mobile computer comes with has been pre-confi gured to support the WLAN device.
• The WLAN device operates in the 2.4 GHz ISM band and the 5 GHz
lower, middle, and upper UNII bands.
• Microwave ovens may interfere with the operation of WLAN devices since they operate in the
same 2.4 GHz frequency range as IEEE802 .11b/g /n devices. Interference by microwaves
does not occur with IEEE802.11a radio which operates in the 5 GHz RF band.
• Wireless devices that transmit in the 2.4 GHz range may interfere with operation of W LAN
devices in IEEE802.11b/g/n modes. Symptoms of interference include reduced throughput,
intermittent disconnects, and many frame errors. It is HIGHLY recommende d that these
interfering devices be powered off to ensure proper operation of the WLAN device.
Fujitsu 77