Photo Scanner User Manual
Table Of Contents
- fi-4860C Operator's Guide
- INTRODUCTION
- CONTENTS
- 1 BASIC SCANNER OPERATIONS
- 2 SCANNING VARIOUS TYPES OF DOCUMENTS
- 3 DAIRY CARE
- 4 REPLACEMENT OF CONSUMABLES
- 5 SOLVING COMMON PROBLEMS
- 6 ADF DOCUMENT SPECIFICATIONS
- 7 SETUP MODE
- 8 OPTIONS
- 9 SCANNER SPECIFICATIONS
- Appendix 1 Drop-Out Color
- Appendix 2 Double-feed Detection Conditions
- Appendix 3 Messages of Operator Panel
● AP-3
Detection by Document Thickness and Length
Sheets of the same thickness and length shall be set in the ADF at a time.
- Document length: 0.065 to 0.15mm
- Document length deviation: 1% or less
- Printed area: 12% or less
- No black printed areas are allowed at the center area (26 x 10mm) at the
leading edge of the document.
- Punched holes are not allowed within 35mm of the vertical center line of the
document.
- The deviation in the amount of the light transmitted through background areas
must not be less than 10%.
HINT
The type and the conditions of document
and the conditions sometimes cause the
double-feed detection rate to drop.