Photo Scanner User Manual
Table Of Contents
- fi-4860C Operator's Guide
- INTRODUCTION
- CONTENTS
- 1 BASIC SCANNER OPERATIONS
- 2 SCANNING VARIOUS TYPES OF DOCUMENTS
- 3 DAIRY CARE
- 4 REPLACEMENT OF CONSUMABLES
- 5 SOLVING COMMON PROBLEMS
- 6 ADF DOCUMENT SPECIFICATIONS
- 7 SETUP MODE
- 8 OPTIONS
- 9 SCANNER SPECIFICATIONS
- Appendix 1 Drop-Out Color
- Appendix 2 Double-feed Detection Conditions
- Appendix 3 Messages of Operator Panel
222
7.5 Test Mode Details
If fi-486PRFR and/or fi-486PRREis installed, <Screen50-3> is displayed fo you to
setup imprinter test conditions.
If an imprinter(s) is not installed, the scanner starts scanning operations.
<Screen50-3>
5) At <Screen50-3>, press (Left arrow button) or (Right arrow button) and:
Select [On] to do imprinter test while scanning.
Then select the imprinter to use.
If the printer to use is fi-486PRFR, select [Pre].
If fi-486PRRE, select [Post].
If imprinter test is not required, select [Off].
6) Press (Start button). Scanning operation starts with or without imprinter test .
HINT
If you want to quit, press (Stop button).
LCD display goes back to <Screen50>.
e
O
=f/fO:Pn
r
n
rPi
t
o
/stP