Photo Scanner User Manual
Table Of Contents
- fi-4860C Operator's Guide
- INTRODUCTION
- CONTENTS
- 1 BASIC SCANNER OPERATIONS
- 2 SCANNING VARIOUS TYPES OF DOCUMENTS
- 3 DAIRY CARE
- 4 REPLACEMENT OF CONSUMABLES
- 5 SOLVING COMMON PROBLEMS
- 6 ADF DOCUMENT SPECIFICATIONS
- 7 SETUP MODE
- 8 OPTIONS
- 9 SCANNER SPECIFICATIONS
- Appendix 1 Drop-Out Color
- Appendix 2 Double-feed Detection Conditions
- Appendix 3 Messages of Operator Panel
177
7.3 Setup Mode Details
7
SETUP MODE
3) In case of (2) or (3), by pressing (Enter button), LCD display changes to
<Screen5-1>.
<Screen5-1>
4) At <Screen5-1>, by pressing (Left arrow button) or (Right arrow button), the
document length can be specified.
By pressing (Right arrow button), selection moves from (1) to (3).
By pressing (Left arrow button), selection moves from (3) to (1).
5) Press (Enter button) and the setting becomes valid.
Press (EXIT button) at <Screen5-1>, then the LCD display changes to
<Screen5>.
Press (EXIT button) again and the LCD display goes back to [Ready] screen.
(1) [10] is blinking: The document length difference below 10mm is not detected
as an error.
(2) [15] is blinking: The document length difference below 15mm is not detected
as an error.
(3) [20] is blinking: The document length difference below 20mm is not detected
as an error.
05
eL
!
n
tg
0
1
5
1/1
0
2/
-
h
mm
=