Datasheet

Copyright 2012 FUJITSU LIMITED
Model Upgrade
for DX90S2 (2.5inch,
single-controller type)
to DX440S2
FTS:ETEU94SC-L
N NNNNNY
*1
NN––––
Currently
Available
• DX440 S2 controller enclosure (3U) x 1
- Controller x 2
- Power supply unit x 2
-Battery unit x 3
- Rack mount kit x 1
• 2.5" drive enclosure (2U) x 1
-I/O module x 2
- Power supply unit x 2
- Rack mount kit x 1
• QSFP cable (1.1m) x 2
• Upgrade license x 1
Additional parts that must be ordered:
• Cache memory for DX440 S2
• Host interface for DX400 S2
• QSFP cable between Drive Enclosure
• Additional IOM
*1: Firmware version V10L25 or later is required for an
ETERNUS DX Disk storage system.
Model Upgrade
for DX90S2 (3.5inch,
single-controller type)
to DX440S2
FTS:ETEU94SD-L
N NNNNNNNY
*1
––––
Currently
Available
• DX440 S2 controller enclosure (3U) x 1
- Controller x 2
- Power supply unit x 2
-Battery unit x 3
- Rack mount kit x 1
• 3.5" drive enclosure (2U) x 1
-I/O module x 2
- Power supply unit x 2
- Rack mount kit x 1
• QSFP cable (1.1m) x 2
• Upgrade license x 1
Additional parts that must be ordered:
• Cache memory for DX440 S2
• Host interface for DX400 S2
• QSFP cable between Drive Enclosure
• Additional IOM
*1: Firmware version V10L25 or later is required for an
ETERNUS DX Disk storage system.
QSFP cable between
Drive Enclosure
FTS:ETEC2Q1-L
N NNNNNNNNYYYY
Currently
Available
• QSFP cable (1.1m) x 2
• Must be ordered when performing the model upgrade to
the DX410 S2/DX440 S2
Product name Product ID
Preinstalled (**)
Product ID
EOL Component items
FTS:ET082DCU FTS:ET082SCU FTS:ET082DDU FTS:ET082SDU FTS:ET092DCU FTS:ET092SCU FTS:ET092DDU FTS:ET092SDU FTS:ETEAD2CU FTS:ETEAD1CU FTS:ETEAD2DU FTS:ETEAD1DU
Y: Supported N: Not supported –: Not applicable
** Y: Preinstalled at the factory (must be ordered with the DX80 S2/DX90 S2) N: Not preinstalled at the factory (packaged separately)
ETERNUS DX80 S2/DX90 S2 Disk storage system
Product List
P3AM-4852-10ENZ0
Date of issuance: December 2012
Issuance responsibility: FUJITSU LIMITED
• The content of this manual is subject to change without notice.
• This manual was prepared with the utmost attention to detail.
However, Fujitsu shall assume no responsibility for any operational
problems as the result of errors, omissions, or the use of information in
this manual.
• Fujitsu assumes no liability for damages to third party copyrights or
other rights arising from the use of any information in this manual.
• The content of this manual may not be reproduced or distributed in part
or in its entirety without prior permission from Fujitsu.