Installation Manual

IntesisHome

IS-IR-WIFI-1 User Manual r1.2 eng

This information is subject to change without notice

IntesisHome

is a registered trademark

of Intesis Software SL

URL

Contact

http://www.intesishome.com

http://www.intesishome.com/contact

16 / 23

6 IR configuration

Once you have the IntesisHome device installed and Wi-Fi configured, you are ready to start the

IR Configuration process. In order to configure the interface from the IR side, please use either

the Learning mode (directly with your AC remote controller) or the Manual mode (using the user

web interface).

6.1 Learning mode

Please, check that the LED device is Off and the IntesisHome device powered before starting

this process.

In order to configure the IntesisHome device to start working with your AC unit using the IR,

please do as follows:

1. Push the IH button for 3 seconds. The LED will turn into white steady.

2. Pick up the IR wireless controller of your AC unit and push the On/Off button pointing to

the IntesisHome Universal device.

• If the IntesisHome device LED starts blinking in Green.

The IR learning process has been successful.

• If the IntesisHome device LED starts blinking in Red.

Repeat the process from step 1 and check our compatibility list. If problem still persists,

please visit our support section at www.intesishome.com/support

• If the IntesisHome device LED turns Off.

Repeat the process from step 1 and check that your IR wireless remote controller has

batteries and that you are pointing directly to the IntesisHome Universal IR receiver.

IMPORTANT: Before starting the IR configuration process, please check the compatibility list

www.intesishome.com/downloads/universal

and make sure that you have the IntesisHome

Universal Controller already connected to the Internet.

NOTE: Make sure that the AC unit is Off and the IR Wireless Controller is showing this

Off status before pressing the On/Off button. In order to ensure the learning process,

please make sure you send an On command

from your IR Wireless controller.