Network Adapter Getting Started fi-5000N
Table Of Contents
- CONTENTS
- INTRODUCTION
- Chapter 1 Overview of fi-5000N
- Chapter 2 Names and Functions of Parts
- Chapter 3 Installing the fi-5000N
- 3.1 Installing the Scanner
- 3.2 Installing the fi-5000N
- 3.3 fi-5000N's Settings and Connecting to the Network
- 3.4 Changing the Language Setting
- 3.5 Automatic Turning Backlight Off Settings
- 3.6 Beep Sound Configuration
- 3.7 Pull Mode User Authentication Settings
- 3.8 Push Mode Automatic Logout Time Settings
- 3.9 Host Connection Time-out
- 3.10 Displaying Device Information
- 3.11 Initialization of fi-5000N
- Chapter 4 Installing and Setting Driver
- Chapter 5 Installing and setting the fi-5000N Software
- Chapter 6 User Authentication
- Chapter 7 Daily Care
- Chapter 8 Troubleshooting
- Chapter 9 Specifications
- APPENDIX Using User Authentication by Fingerprint
- INDEX
62
Also, messages such as the following may appear while using the scanner.
If this message appears, follow the instructions below to replace the consumables.
After clicking the [Ignore] button, this message will disappear and scanning will continue. Please
replace the consumable as soon as possible.
This message appears again after certain number of scans. If you do not wish this message to be
displayed, select the [This message not display again] check box.
To stop scanning and replace the consumable, click the [Cancel] button.
If the consumables are replaced, reset the consumable counters by clicking the [Clear] buttons
located in the [Device Set] tab.
About the Power Saving Settings
Specifies the timer of the lamp to turn off after scanning.
*The timer value range differs depending on the scanner.