Network Adapter Getting Started fi-5000N
Table Of Contents
- CONTENTS
- INTRODUCTION
- Chapter 1 Overview of fi-5000N
- Chapter 2 Names and Functions of Parts
- Chapter 3 Installing the fi-5000N
- 3.1 Installing the Scanner
- 3.2 Installing the fi-5000N
- 3.3 fi-5000N's Settings and Connecting to the Network
- 3.4 Changing the Language Setting
- 3.5 Automatic Turning Backlight Off Settings
- 3.6 Beep Sound Configuration
- 3.7 Pull Mode User Authentication Settings
- 3.8 Push Mode Automatic Logout Time Settings
- 3.9 Host Connection Time-out
- 3.10 Displaying Device Information
- 3.11 Initialization of fi-5000N
- Chapter 4 Installing and Setting Driver
- Chapter 5 Installing and setting the fi-5000N Software
- Chapter 6 User Authentication
- Chapter 7 Daily Care
- Chapter 8 Troubleshooting
- Chapter 9 Specifications
- APPENDIX Using User Authentication by Fingerprint
- INDEX
46
■ [Launch Option] Tab
The scanning application to be started when the button on the scanner ([Scan] or [Send To]) is
pressed, can be configured from this screen.
Name of Item Function
Button: Selects the button to be configured from among "Scan", and
"Send To 1 - Send To 9". You must set the following "Target",
"Argument" and "Start In", otherwise no application will start up.
Target: Specifies the file name of the application to be started.
Argument: Configures the argument to be passed to the specified applica-
tion that is started.
With this function, you can also add more actions than just start
the scanning application when scanner button is pressed.
The argument that can be specified differs depending on the
application being used.
(Refer to "5.7 Settings of [Launch Options]" (page 64) for
details.)
Start In: Specifies the default folder when the application starts.