Network Adapter Getting Started fi-5000N
Table Of Contents
- CONTENTS
- INTRODUCTION
- Chapter 1 Overview of fi-5000N
- Chapter 2 Names and Functions of Parts
- Chapter 3 Installing the fi-5000N
- 3.1 Installing the Scanner
- 3.2 Installing the fi-5000N
- 3.3 fi-5000N's Settings and Connecting to the Network
- 3.4 Changing the Language Setting
- 3.5 Automatic Turning Backlight Off Settings
- 3.6 Beep Sound Configuration
- 3.7 Pull Mode User Authentication Settings
- 3.8 Push Mode Automatic Logout Time Settings
- 3.9 Host Connection Time-out
- 3.10 Displaying Device Information
- 3.11 Initialization of fi-5000N
- Chapter 4 Installing and Setting Driver
- Chapter 5 Installing and setting the fi-5000N Software
- Chapter 6 User Authentication
- Chapter 7 Daily Care
- Chapter 8 Troubleshooting
- Chapter 9 Specifications
- APPENDIX Using User Authentication by Fingerprint
- INDEX
42
5.1 Installing fi-5000N Software
■ Preparation
Before starting the installation, check the following contents.
• Prepare the Setup CD-ROM
■ System Requirements
The system requirements for the fi-5000N is as follow.
•
Operating System
Microsoft Windows 98
Microsoft Windows 2000 Professional
Microsoft Windows Millennium Edition
Microsoft Windows XP Professional
Microsoft Windows XP Home Edition
• RAM
128 MB or higher
■ Installing
1. Turn on the power of the PC, and log on to Windows.
2. Insert the Setup CD-ROM into the CD drive.
⇒ <SETUP DISK START UP SCREEN> appears.
HINT
Windows XP screenshots are used in this section as examples. The
windows and operations may slightly vary depending on your OS.
ATTENTION
When using Windows 2000 or Windows XP, log on as a user with
"Administrator" rights.
ATTENTION
This screen may not appear when the "Autoplay" setting of your PC is OFF.
In this case, run "Install.exe" in this CD-ROM directly from the "Explorer" or
"My Computer".