Network Adapter Getting Started fi-5000N
Table Of Contents
- CONTENTS
- INTRODUCTION
- Chapter 1 Overview of fi-5000N
- Chapter 2 Names and Functions of Parts
- Chapter 3 Installing the fi-5000N
- 3.1 Installing the Scanner
- 3.2 Installing the fi-5000N
- 3.3 fi-5000N's Settings and Connecting to the Network
- 3.4 Changing the Language Setting
- 3.5 Automatic Turning Backlight Off Settings
- 3.6 Beep Sound Configuration
- 3.7 Pull Mode User Authentication Settings
- 3.8 Push Mode Automatic Logout Time Settings
- 3.9 Host Connection Time-out
- 3.10 Displaying Device Information
- 3.11 Initialization of fi-5000N
- Chapter 4 Installing and Setting Driver
- Chapter 5 Installing and setting the fi-5000N Software
- Chapter 6 User Authentication
- Chapter 7 Daily Care
- Chapter 8 Troubleshooting
- Chapter 9 Specifications
- APPENDIX Using User Authentication by Fingerprint
- INDEX
3.2 Installing the fi-5000N
fi-5000N Operator’s Guide 13
Installing the fi-5000N
3
3. Connect the USB cable to the USB connector.
4. Connect the other end of the USB interface cable to the scanner.
ATTENTION
Be sure to use the USB cable provided with the scanner. Correct operation
with commercially available cables is not guaranteed.
ATTENTION
The message "Scanner is disconnected" is displayed on the Message Dis-
play of fi-5000N if the scanner is not connected properly, or if the power of
the scanner is turned off. Check the connection of the scanner when it hap-
pens. Refer to the scanner product manual for details on turning on the
power of the scanner.