ASU7RLF1 Operation Manual

En-5
PREPARATION
CAUTION!
●
Take care to prevent infants from acci-
dentally swallowing batteries.
●
When not using the Remote Control-
ler for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
●
If leaking battery fl uid comes in contact
with your skin, eyes, or mouth, imme-
diately wash with copious amounts of
water, and consult your physician.
●
Dead batteries should be removed imme-
diately and disposed of properly, either
in a battery collection receptacle or to the
appropriate authority.
●
Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year un-
der normal use. If the Remote Control-
ler's operating range becomes appreci-
ably reduced, replace the batteries and
press the RESET button with the tip of
a ballpoint pen or other small object.
Load Batteries (AAA/R03/LR03
×
2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 5
P
).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET ( / ) buttons (Fig. 5
O
) to
adjust the clock to the current time.
button:
Press to advance the time.
button:
Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed
in 5 minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3
Press the CLOCK ADJUST button (Fig. 5
P
) again.
This completes the time setting and starts the clock.
To Use the Remote Controller
●
The Remote Controller must be pointed at signal receiver (Fig. 3
4
) to operate
correctly.
●
Operating Range: About 23ft (7 m).
●
When a signal is properly received by the indoor unit, a beeping sound will be
heard.
●
If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
3 To remove the Remote Con-
troller (when use at hand).
1 Mount the Holder. 2 Set the Remote Controller.
Screws
Insert
Press in
Slide up
Pull out
Turn on the Power
1
Turn on the circuit breaker
9332280012-03_EN.indd 59332280012-03_EN.indd 5 8/27/2010 3:13:23 PM8/27/2010 3:13:23 PM