User Manual

F-10C_EN_ninshou
22
Introduction
After using the external connection jack, close
the cap as the direction shown in the, and make
sure that the cap is completely closed without
slack by pushing the tab in.
・ For installing the back cover, see "Installing back
cover" of "Attaching UIM/battery pack".
⇒ P26
・ Securely lock the back cover and firmly close the
external connection jack cap. Even a fine
obstacle (one hair, one grain of sand, tiny fiber,
etc.) put between contact surfaces may allow
water to enter.
・ Do not poke the microphone, earpiece or
speaker with a swab or sharp object.
・ Do not let FOMA terminal fall. It may become
scratched causing the waterproof/dustproof
performance to degrade.
・ The external connection jack cap and the rubber
packing of the rear side of the back cover play an
important role for keeping waterproof
performance. Do not deform the back cover by
twisting etc. or peel off or damage the rubber
packing. Also, prevent dust from adhering to it.
To keep FOMA terminal waterproofness/
dustproofness, replacement of parts is required
every 2 years regardless of whether FOMA
terminal appears normal or abnormal.
DOCOMO replaces the parts as a chargeable
service. Bring FOMA terminal to a sales outlet
such as a DOCOMO-specified repair office.
Important precautions
Do not perform actions shown in the
illustrations below.
Observe the following precautions to use
FOMA terminal properly.
・ Accessories and optional devices are not
waterproof/dustproof. When watching 1Seg etc.
with FOMA terminal installed in the included
desktop holder, do not use it in a bathroom,
shower room, kitchen or lavatory even if it is not
connected to the AC adapter.
・ Do not apply water flow stronger than allowed (
⇒ P21) (e.g., such water flow that gives you pain
when applied to your skin directly from a faucet
or shower). F-10C provides IPX5 waterproof
performances. However, it causes malfunction.
・ If FOMA terminal gets wet with salt water, sea
water, refreshing beverage or mud or soil
adhered, wash it immediately. If they dry out, it
is hard to remove the dirt and it may cause
damage or malfunction.
・ Do not put FOMA terminal in hot water, use it in
a sauna or apply hot airflow (from a hair dryer
etc.) to it.
Tab
<Example>
Using Soap/Detergent/
Bath powder
Soaking in
ocean water
Applying strong
water flow
Using in
hot spring
Machine-washing
Washing with
brush/sponge