User Manual

F-07C_EN_ninshou
20
Basic Operation
Before Using
Attaching UIM/battery pack
Turn the power OFF, close and hold the FOMA
terminal in your hand to attach UIM/battery pack
properly.
✜ Removing back cover
With pressing the back cover with your thumb, slide
approximately 3 mm in the direction of the arrow to
remove it.
✜ Installing UIM
Pull the tab with your nail and pull out the tray until
it clicks (
a ). Hold UIM with the IC side up, align the
beveled corner with the tray (
b ) and push into the
tray until it stops (
c ).
✜ Attaching battery pack
With label side of the battery pack up, align convex
parts of the battery pack with concave parts of the
FOMA terminal, slide the battery pack in the
direction of
a and then press it in the direction of
b to set in.
✜ Attaching back cover
Place the 7 tabs of back cover to the notches of the
FOMA terminal, press the back cover in the
direction of
a to avoid forming any clearance
between them, then slide it in the direction of
b to
attach.
Point
･ UIM (blue) is not available for this FOMA terminal. If
you have the UIM (blue), bring it to a docomo Shop.
Press here with thumb
Back cover
IC
Corner cut
UIM
Tray
Tab
Battery pack
Concave
parts
Convex parts
Back cover