User Manual

Before Using the Terminal
20
F-06C_OP_1kou
◆ Removing
1
Exit communication connection
If the F-06C Connection Software is running, close it. Make sure the data
connection is disconnected.
2
Fold up the antenna
3
Hold both sides of the Xi/FOMA dual terminal and pull it out from the
ExpressCard slot of the PC along the arrow direction
❖ To remove from the PC card slot (Only for Windows)
〈 Example 〉 For Windows 7
a Double click $$ on the task tray at lower-right of display
Icon on the task tray of Windows Vista: $$
Icon on the task tray of Windows XP: $$
b Check " デバイスコンポーネントを表示する (Display device component)" and
check under which controller the Xi/FOMA dual terminal (F-06C) is recognized
･ Xi/FOMA dual terminal (F-06C) is recognized under " 標準エンハンス PCI to USB
ホスト コントローラ (Standard and enhancement PCI to USB host controller)".
c On the screen as shown above, select " 標準エンハンス PCI to USB ホスト コント
ローラ (Standard and enhancement PCI to USB host controller)" and click [ 停止
(Stop)]
d Select " 標準エンハンス PCI to USB ホスト コントローラ (Standard and
enhancement PCI to USB host controller)" and click [OK]
ExpressCard slot
F-06C_E.book Page 20 Tuesday, February 1, 2011 1:57 PM