User Manual

F-04D_EN_ninshou
26
Basic Operation
Before Using
Attaching miniUIM/battery pack
After turning power OFF, close FOMA terminal
and hold it in your hand so that you can properly
attach UIM/battery pack.
✜ Removing back cover
✜ Attaching miniUIM
Point
･ A UIM or FOMA card is not available for this FOMA
terminal. Replace it with a miniUIM at a docomo
Shop.
✜ Installing battery pack
✜ Installing back cover
b Press and slide the back cover
in the arrow direction approx.
2 mm to remove
a Slide the lever in a direction to
unlock
Back cover
With facing IC side of the docomo mini UIM card down,
insert to the slot slowly and push it until it clicks
IC
Corner cut
docomo mini UIM card
With the label side up, fit
the convex parts to the
concave parts of the FOMA
terminal and insert in the
a
direction, then push in the
b direction to set in.
Convex parts
Concave parts
b
a
cc
b Slide the lever in the arrow direction
to lock
a Fit the 8 tabs to the notches of the
FOMA terminal and push in the
direction
a not to forming any
clearance, then slide in the
direction
b