User Manual
Table Of Contents
F-04C_EN_ninshou
17
Basic Operation
Before Using
Attaching UIM/battery pack
After turning power OFF, close FOMA terminal and hold it in your
hand so that you can properly attach UIM/battery pack.
✜
Removing Back Cover
Slide the lever in the direction of
a
to unlock, hold the FOMA terminal
firmly with one hand not to slide, press the back cover with a thumb of
the other hand and slide approximately 3mm in the direction of
b
to
remove.
✜
Attaching UIM
Pull the tab with your nail and pull out the tray until it clicks (
a
). Hold
UIM with the IC side down, align the corner cut with the tray (
b
) and
push into the tray until it stops (
c
).
Point
･
UIM (blue) is not available for this FOMA terminal. If you have the UIM
(blue), bring it to a docomo Shop.
✜
Installing battery pack
With the label side of the battery pack upward, align convex parts of
the battery pack with concave parts of FOMA terminal and insert the
battery pack in the direction of
a
, press the battery pack in the
direction of
b
to set it in.
✜
Installing back cover
Align the 8 tabs of the back cover to the notches of the FOMA terminal,
press the back cover in the direction of
a
without forming any gap
between the FOMA terminal and back cover and slide it in the
direction of
b
to install.
Press here with your thumb
Back cover
Tray
Tab
IC
Corner cut
UIM
Convex parts
Concave parts
Battery pack
b
a
Back cover