User Manual Part 3

F-04B_E1kou
21
Basic Operation
While using detached keypad unit, HID support device (for key
entering) or HFP and HSP support device (for talking) cannot be
used at the same time. To use those Bluetooth devices, perform
any of following procedures.
【 Procedure 1 】 Attaching keypad unit
Attach keypad unit to display unit to end Bluetooth
communication of the keypad unit.
【 Procedure 2 】 Selecting registered Bluetooth device
When keypad unit is detached, mef*bemd to
disconnect connection of keypad unit, select Bluetooth device to
use and connect it.
Point
･ Please verify the power of keypad unit OFF after turning the power of
display unit OFF in areas where use is prohibited, such as in airplanes and
hospitals.
･ When Continuous connection is set to "ON", battery power consumption
is increased.
Cautions on using detached keypad unit
Before Using
Attaching UIM (FOMA card)/battery pack
Set UIM (FOMA card) to display unit. For attaching/removing
battery pack or UIM, separate the FOMA terminal, turn off the
power of display unit and perform properly with holding display
unit in hand.
✜ Removing Back Cover F45
With pressing the back cover with your thumb, slide approximately 3
mm in the direction of the arrow to remove it.
✜ Installing UIM
Pull the tab with your nail and pull out the tray until it clicks ( a ). Hold
UIM with the IC side up, align the beveled corner with the tray ( b )
and push into the tray until it stops ( c ).
Attaching to display unit
Press here with your thumb
Back cover
IC
Corner
cut
UIM
Tray
Tab