User Manual Part 4

F-03B_EN_FCC
18
Introduction
✜ What you can do with waterproofness and
dustproofness of F-03B
・ You can talk or watch 1Seg programs without using an umbrella in
the rain (for rainfall of 20 mm or less per hour).
- When your hands or FOMA terminal are wet, avoid installing/
removing the back cover or opening/closing the external
connection jack cap.
・ You can wash mud or dirt away.
- If FOMA terminal gets dirty, flush away immediately as predefined
( ⇒ P20).
・ You can touch the terminal with your hand that is wet with salt
water or seawater.
- Do not operate the terminal.
- If you touch the terminal with your wet hand, flush away
immediately as predefined ( ⇒ P20).
・ You can also shoot still images and moving pictures in the pool
depth of 1.5 m.
- Do not perform other operations underwater than shooting still
images and moving pictures.
- If you put the terminal in water of swimming pool, be sure to have
it within 30 minutes.
- If FOMA terminal gets wet with water from the swimming pool,
wash it as predefined ( ⇒ P20).
・ You can use FOMA terminal in a bathroom.
- Do not put the terminal in the bathtub. Do not use the terminal in
hot water. Doing so may cause malfunction.
- Never put FOMA terminal in hot spring water or water containing
soap, detergent or bath powder.
To ensure waterproofness/dustproofness
To avoid water and dust ingress, be sure to observe the following
points.
・ If FOMA terminal should get wet with salt water, sea water or soft
drink, you can flush away. However, do not let the terminal get wet
with liquids other than tap water at room temperature.
・ Open/close the external connection jack cap as described below.
<Opening the external connection jack cap>
Place your finger at groove on the hinge side to open the cap.
<Closing the external connection jack cap>
Close with the tab for the back cover at the rear side of the cap fitted
into the concave of this terminal. Make sure that the cap is
completely closed without slack.
Groove on the hinge side
T
ab on the back
cover side