User Manual Part 2

F-02D_EN_ninshou
26
Basic Operation
Before Using
Attaching miniUIM/battery pack
After turning power OFF, close FOMA terminal
and hold it in your hand so that you can properly
attach UIM/battery pack.
✜ Removing back cover
✜ Attaching miniUIM
Point
･ A UIM or FOMA card is not available for this FOMA
terminal. Replace it with a miniUIM at a docomo
Shop.
✜ Installing battery pack
✜ Installing back cover
b Press and slide the back cover
in the arrow direction approx.
2 mm to remove
a Slide the back cover in the
arrow direction to unlock
Back cover
With facing IC side of the mini UIM down, insert
to the slot slowly and push it until it clicks
IC
Corner cut
mini UIM
With the label side up, fit the
convex parts to the concave
parts of the FOMA terminal
and insert in the
a direction,
then push in the
b direction
to set in.
Convex parts
Concave parts
aa
b
c
b Slide the lever in the arrow direction
to lock
a Fit the 8 tabs to the notches of the
FOMA terminal and push in the
direction
a not forming any
clearance, then slide in the
direction
b .