User Manual
F-02C_EN_ninshou
22
Basic Operation
Before Using
Attaching docomo UIM/battery pack
After turning power OFF, close FOMA terminal and hold it in your
hand so that you can properly attach UIM/battery pack.
✜
Removing back cover
Slide the lever in the direction
a
to unlock, hold the FOMA terminal
firmly with your hand not to slide, and then slide the back cover in the
direction
b
by 2 mm with a thumb of the other hand to remove it.
✜
Attaching docomo UIM
Pull the tab with your nail and pull out the tray until it clicks (
a
). Hold
docomo UIM with the IC side down, align the corner cut with the tray
(
b
) and push into the tray until it stops (
c
).
Point
･
docomo UIM (blue) is not available for this FOMA terminal. If you have the
docomo UIM (blue), bring it to a docomo Shop to replace.
✜
Installing battery pack
With the label side of the battery pack upward, align convex parts of
the battery pack with the concave parts of the FOMA terminal and
slide the battery pack in the direction
a
, press the battery pack in the
direction
b
to set it in.
✜
Installing back cover
Place the 8 tabs of back cover to the notches, press back cover in the
direction of
a
to avoid forming any clearance between FOMA
terminal and back cover, then slide it in the direction of
b
to install it.
Finally, slide the lever in the direction of
c
to lock.
Point
･
Firmly attach the back cover and lock it with the lever to avoid water or
dust ingress.
･
The rubber packing of the rear side of the back cover play an important
role for keeping waterproofness/dustproofness. Do not remove or scratch
it. Also, prevent dust from adhering to it.
Press here with your thumb
Back cover
Lever
Tr
ay
Tab
IC
Corner cut
docomo UIM
Convex parts
Concave parts
Battery pack
B
ack cover
a
b
Lever
c