User Manual

F-02C_EN_ninshou
20
Introduction
・ If FOMA terminal gets wet with water or other liquids with the
external connection jack cap or the back cover opened, the liquid
may get inside the terminal causing electric shocks or malfunction.
Stop using FOMA terminal, turn the power OFF, remove the battery
pack and contact a DOCOMO-specified repair office.
・ If the external connection jack cap or the rubber gasket on the rear
side of the back cover is damaged or deformed, replace it at
DOCOMO-specified repair office.
DOCOMO does not guarantee actual operations under all states.
Malfunctions deemed to be caused by inappropriate operation by the
customer are not covered by the warranty.
With pressing and holding the external connection jack cap not to
open, wash the terminal in tap water without rubbing hard.
・ Do not apply water flow stronger than allowed ( ⇒ P17) (e.g., such
water flow that gives you pain when applied to your skin directly
from a faucet or shower).
・ In locked state with the back cover attached, with pressing and
holding the external connection jack cap not to open, wash the
terminal in tap water in room temperature without rubbing hard.
・ Do not use brush, sponge, soap, detergent, etc.
・ If mud or soil is adhered to the terminal, do not open or close the
terminal. Eliminate the dirt first by shaking several times in tap water
of wash-basin and then wash the terminal with running water.
・ After washing, wipe the surface with dry cloth well, drain water by
the following procedure and let the terminal dry naturally.
When FOMA terminal is wet, water may flow out after wiping it off;
drain the water in the following steps.
a Wipe moisture on FOMA terminal surface off with dry, clean cloth
etc.
Washing FOMA terminal
Press here
Draining water from FOMA terminal