User Manual
F-02C_EN_ninshou
18
Introduction
・
You can also shoot still images and moving pictures in the pool
depth of 1.5 m.
- Do not perform other operations underwater than shooting still
images and moving pictures.
- If you put the terminal in water of swimming pool, be sure to have
it within 30 minutes.
- If FOMA terminal gets wet with water from the swimming pool,
wash it in specified procedure (
⇒
P20).
・
You can use FOMA terminal in a bathroom.
- Do not put the terminal in the bathtub. Do not use the terminal in
hot water. May cause malfunction.
- Never put FOMA terminal in hot spring water or water containing
soap, detergent or bath powder.
To ensure waterproofness/dustproofness
To avoid water/dust ingress, be sure to observe the following points.
・
Do not throw any liquid other than room-temperature tap water on
FOMA terminal, or soak it in such liquid.
・
Open/close the external connection jack cap as described below.
<Opening the external connection jack cap>
Pull the cap up with your finger by the groove.
<Closing the external connection jack cap>
Close the external connection jack cap not giving any gap with FOMA
terminal by firmly pressing in the direction of arrow mark. Make sure
that the cap is completely closed without slack.
・
Install the back cover as described below.
<Installing the back cover>
Align 8 tabs of the back cover with concaves of FOMA terminal.
While pressing the back cover in the direction of
a
so that there is
no gap between FOMA terminal and back cover, slide the back cover
in the direction of
b
to install, then slide the back cover lever in the
direction of
c
to lock.
*
Make sure that the back cover is completely closed without slack. Slide the
back cover in the direction of the arrow shown on the lever, and then make
sure the cover is securely locked before using.
Grooves on hinge side
T
abs on back cover
side
b
a
Back cover
Lever
c