User Manual Part 2

F-02B_EN_ninshou
18
Introduction
Waterproofness/Dustproofness
F-02B is provided with the following waterproofness by firmly closing the
external connection jack cap, installing the back cover and locking the
cover.
・ IPX5 (Former JIS protection code 5)
*1
・ IPX8
*3
that is a higher standard than IPX7 (former JIS protection code
7)
*2
Also, F-02B is dustproof to IP5X (former JIS protection code 5)
*4
if the
external connection jack cap is strictly closed as well as the back cover is
mounted and locked.
*1 Code IPX5 means that a phone keeps functioning after directly applying a jet
flow of 12.5 L/min. for at least 3 minutes from a distance of 2.5-3 m on a
rotating turntable.
*2 Code IPX7 means that a phone keeps functioning after it is slowly submerged
to depth of 1 m in static tap water at room temperature, left there for 30
minutes and then taken out.
*3 Code IPX8 means that it provides waterproofness of which exceeds of IPX7
standard.
*4 Code IP5X means that a device is protected against the ingress of dust specific
to dustproof test (25
μ m or smaller in diameter), so that the ingress will not
interfere with predefined operation and safety of the device.
F-02B provides the following waterproof performances of IPX8.
･ F-02B keeps functioning after it is slowly submerged to depth of 1.5 m in
static tap water at room temperature, left there for 30 minutes and then taken
out.
･ The mobile phone keeps shooting still images or moving pictures in 30
minutes in static tap water at room temperature.
✜ What you can do with waterproofness and
dustproofness of F-02B
・ You can talk or watch 1Seg programs without using an umbrella in the
rain (for rainfall of 20 mm or less per hour).
- When your hands or FOMA terminal are wet, avoid installing/removing the back
cover or opening/closing the external connection jack cap.
・ You can wash mud or dirt away.
- Do not apply water flow stronger than allowed (e.g., such water flow that gives
you pain when applied to your skin directly from a faucet or shower).
- Wash it using room-temperature tap water with your hand, with FOMA terminal
locked, the back cover installed and the external connection jack cap held in
position.
- Do not use any brush, sponge, soap, cleaning material, etc.
- After flushing away, wipe off water with a dry cloth, drain, and dry naturally.
・ You can touch the terminal with your hand that is wet with salt water
or seawater.
- Do not operate the terminal.
- If you touch the terminal with your wet hand, flush away immediately as
predefined.
・ You can also shoot still images and moving pictures in the pool depth
of 1.5 m.
- Do not perform other operations underwater than shooting still images and
moving pictures.
- If you put the terminal in water of swimming pool, be sure to have it within 30
minutes.
- If FOMA terminal gets wet with water from the swimming pool, wash it as
predefined.
・ You can use FOMA terminal in a bathroom.
- Do not put the terminal in the bathtub. Do not use the terminal in hot water.
Doing so may cause malfunction.
- Never put FOMA terminal in hot spring water or water containing soap,
detergent or bath powder.
To ensure waterproofness/dustproofness
To keep the FOMA terminal waterproof/dustproof, be sure to observe the
points below.
・ If FOMA terminal should get wet with salt water, sea water or soft drink, you can
flush away. However, do not let the terminal get wet with liquids other than tap
water at room temperature.