User's Manual
F-01D_EN_ninshou.pdf
Contents/Precautions
12
◆
General
・
F-01D is waterproof, however, do not allow water to
seep into the Xi terminal and do not allow accessories
or optional devices to get wet.
- Adapter, desktop holder, miniUIM are not waterproof.
Do not use in a bathroom or other highly humid area
or do not let rain attached. Or putting the terminal on
your body, humidity of sweat may cause internal
corrosion and malfunction. Note that malfunctions,
which are determined to be caused by water as result
of inspections, are not covered by the warranty. Since
these conditions are outside the scope of the warranty,
a repair, if at all possible, is charged.
・
Clean the Xi terminal with a dry soft cloth (such as a
cloth for eyeglasses).
- Rubbing it roughly with a dry cloth may scratch the
display.
- Drops of water or dirt left on the display may cause
stains.
- If the Xi terminal is wiped with alcohol, paint thinner,
benzine or detergent, the printing may disappear or
color may fade.
・
Clean the jack occasionally with a dry cotton swab etc.
- If the jack is soiled, connection gets worse and it may
cause power to be turned off or insufficient battery
charge, so clean the jack with a dry cotton swab etc.
Also, be careful never to damage the jack when
cleaning it.
・
Do not place the Xi terminal near an air-conditioner
outlet.
- The rapid change in temperature may cause
condensation, causing internal corrosion and
malfunction.
・
When using, be careful not to subject excessive force to
the Xi terminal, etc.
- If the Xi terminal is crammed into a brimming bag,
display or internal PCBs may be damaged or
malfunction. And, if external devices are plugged into
the external connection jack (earphone/microphone
jack), the breakage of the connector or malfunction
may result.
・
Do not rub or scrape the display with a metal piece etc.
- May scratch the display, causing malfunction or
damage.
・
Carefully read the separate instructions that come with
the adapter.
◆
Xi terminal
・
Do not press the surface of the touch panel strongly or
operate it with sharp objects such as a nail, a ballpoint
pen and a pin.
- It may damage the touch panel.
・
Avoid extreme temperature.
- Use the Xi terminal where the temperature ranges
between 5 and 40
℃
(limited to the temporary use in a
bathroom etc. when temperature is above 36
℃
) and
humidity ranges between 45 and 85%.
・
The Xi terminal may affect land-line phones, TVs or
radios in use nearby, so use it as far as possible from
these appliances.
・
Maintain a separate record of the data you saved in the
Xi terminal.
- If the data is deleted, DOCOMO assumes no
responsibility for the loss of any data.
・
Do not drop the Xi terminal or subject it to shocks.
- May cause malfunction or damage.
・
Do not plug external devices into the external
connection jack (earphone/microphone jack) at a slant,
or do not pull it forcibly while it is plugged.
- May cause malfunction or damage.
・
It is normal for the Xi terminal to become warm during
use or charging. Continue to use it.
Handling precautions