User Manual Part 3

Table Of Contents

F-01B_usugata_1kou_0729

Introduction

・

Open/close the external connection jack cap as described below.

Place your finger at groove on the hinge side to open the cap.

Close with the tab for the back cover at the rear side of the cap fitted into the

concave of this terminal. Make sure that the cap is completely closed without

slack.

・

Install the back cover as described below.

Align 8 tabs of the back cover with concaves of FOMA terminal. While pressing the

back cover in the direction of

so that there is no gap between FOMA terminal

and back cover, slide the back cover in the direction of

to install, then slide the

back cover lever in the direction of

to lock.

* Make sure that the back cover is completely closed without slack. Slide the

back cover in the direction of the arrow shown on the lever, and then make

sure the cover is securely locked before using.

・

Securely lock the back cover and firmly close the external connection jack cap.

Even a fine obstacle (one hair, one grain of sand, tiny fiber, etc.) put between

contact surfaces may allow water to enter.

・

Do not poke the microphone, earpiece or speaker with a swab or sharp object.

・

Do not let FOMA terminal fall. It may become scratched causing the waterproof/

dustproof performance to degrade.

・

The external connection jack cap and the rubber packing of the inner lid play an

important role for keeping waterproof/dustproof performance. Do not remove or

scratch it. Also, prevent dust from adhering to it.

Groove on the hinge side

Tab on the back

cover side

Back cover

Lever