User Manual Part 2
F-01B_usugata_1kou_0729
16
Introduction
Handling precautions
・
F-01B is waterproof/dustproof, however, do not allow water or dust to
seep into FOMA terminal and do not allow accessories or optional
devices to get wet or let dust attach.
- FOMA terminal is provided with waterproofness/dustproofness of IPX5 and IPX8
(which exceeds IPX7) by firmly closing the external connection jack cap and
installing the back cover in a locked state, however, it is not complete
waterproofness/dustproofness. Do not install/remove the battery pack or do not
open/close the external connection jack cap and back cover in the rain or with
waterdrop adhered to them. Water may seep inside and cause corrosion or
malfunction. Also, accessories and optional devices are not waterproof/
dustproof. Malfunctions, which are determined to be caused by water or dust as
result of inspections, are not covered by the warranty. Since these conditions are
outside the scope of the warranty, a repair, if at all possible, is charged.
・
Clean FOMA terminal with a dry soft cloth (such as a cloth for
eyeglasses).
- The display of FOMA terminal may have been applied special coating to improve
clearness of the color LCD. When cleaning FOMA terminal, rubbing it roughly
with a dry cloth can scratch the display. Take care when handling the unit, and
clean it with a dry soft cloth (such as a cloth for eyeglasses). Drops of water or
dirt left on the display can cause stains or remove the coating.
- If FOMA terminal is wiped with alcohol, paint thinner, benzine or detergent, the
printing may disappear or color may fade.
・
Clean the jack occasionally with a dry cotton swab etc.
- If the jack is soiled, connection gets worse and it may cause power to be turned
off or insufficient battery charge, so clean the jack with a dry cotton swab etc.
Also, be careful never to damage the jack when cleaning it.
・
Do not place FOMA terminal near an air-conditioner outlet.
- The rapid change in temperature may cause condensation, causing internal
corrosion and malfunction.
・
When using, be careful not to subject excessive force to FOMA terminal
or the battery.
- If FOMA terminal is crammed into a brimming bag or placed in a pocket and sat
on, display, internal PCBs or battery pack may be damaged or malfunction. And,
if external devices are plugged into the external connection jack (earphone/
microphone jack), the breakage of the connector or malfunction may result.
・
Carefully read the separate instructions that come with FOMA
terminal, adapter and desktop holder.
・
Do not rub or scrape the display with a metal piece etc.
- It may scratch the display, causing malfunction or damage.
・
Do not press the surface of the touch panel strongly or operate it with
sharp objects such as a nail, a ballpoint pen and a pin.
- It may damage the touch panel.
・
Avoid extreme temperature.
- Use FOMA terminal where the temperature ranges between 5 and 40
℃
(limited
to the temporary use in a bathroom etc. when temperature is above 36
℃
) and
humidity ranges between 45 and 85%.
・
FOMA terminal may affect land-line phones, TVs or radios in use
nearby, so use it as far as possible from these appliances.
・
Maintain a separate record of the data you saved in your FOMA
terminal.
- If the data is deleted, DOCOMO assumes no responsibility for the loss of any
data.
・
Do not drop FOMA terminal or subject it to shocks.
- May cause malfunction or damage.
・
Do not plug external devices into the external connection jack
(earphone/microphone jack) at a slant, or do not pull it forcibly while it
is plugged.
- May cause malfunction or damage.
・
Do not close FOMA terminal with the strap etc. held inside.
- May cause malfunction or damage.
General
FOMA terminal