User Manual

ManualsBrandsFujitsu ManualsCell PhonesFujitsu F-01A Cellular Phone

Easy Search/Contents/Precautions

F-01A_E1kou

Waterproofness

F-01A is waterproof to IPX5 (former JIS protection code 5)

and IPX7 (former JIS

protection code 7)

standards if the external connection jack cap is strictly closed

as well as the back cover is mounted and locked.

IPX5 means that F-01A phone keeps functioning after directly applying a jet flow of 12.5 L/

min. for at least 3 minutes from a distance of 2.5-3 m on a rotating turntable.

IPX7 means that F-01A phone keeps functioning after it is slowly submerged to depth of 1 m

in static tap water at room temperature, left there for 30 minutes and then taken out.

❖

Advantages in actual operation

・

You can talk or watch 1Seg programs without using an umbrella in the rain (for

rainfall of 20 mm or less per hour).

When your hands or FOMA terminal are wet, avoid installing/removing the back cover or

opening/closing the external connection jack cap.

・

You can wash the FOMA terminal by submerging and moving it forth and back in

still water in a basin etc.

When washing, use only your hands, not a brush or sponge, with FOMA terminal locked,

the back cover installed and the external connection jack cap held in position.

・

You can use the FOMA terminal in a poolside area. Do not put the terminal in the

water of a swimming pool.

If FOMA terminal gets wet with water from the swimming pool, wash it as described above.

Do not use FOMA terminal underwater. May cause malfunction.

・

You can use FOMA terminal in a bathroom. Do not put the terminal in the bathtub.

Never put FOMA terminal in hot spring water or water containing soap, detergent or bath

powder.

Do not use FOMA terminal underwater. May cause malfunction.

◆

Important precautions

To keep the FOMA terminal waterproof, be sure to observe the points below.

・

Securely close the external connection jack cap and back cover.

・

Make sure that the cap and back cover are completely closed without floating.

・

Before using, make sure that the back cover lever is at the LOCK position.

■

Closing external connection jack cap

■

Installing back cover

Align 8 tabs of the back cover with concaves of FOMA terminal. While pressing

the back cover in the direction of

so that there is no gap between FOMA

terminal and back cover, slide the back cover in the direction of

to install.

Back Cover

F-01A.book Page 20 Tuesday, September 2, 2008 6:34 PM

Summary of content (21 pages)

PAGE 1
F-01A_E1kou F-01A.book Page 20 Tuesday, September 2, 2008 6:34 PM ◆ Important precautions Waterproofness F-01A is waterproof to IPX5 (former JIS protection code 5)*1 and IPX7 (former JIS protection code 7)*2 standards if the external connection jack cap is strictly closed as well as the back cover is mounted and locked. *1 IPX5 means that F-01A phone keeps functioning after directly applying a jet flow of 12.5 L/ min. for at least 3 minutes from a distance of 2.5-3 m on a rotating turntable.
PAGE 2
F-01A_E1kou F-01A.book Page 21 Tuesday, September 2, 2008 6:34 PM b Lock the back cover by sliding its lever in the direction of the arrow. Lever ・ Securely lock the back cover and firmly close the external connection jack cap. ・ Do not use FOMA terminal underwater (including opening/closing and keypad operations). ・ Do not let FOMA terminal get wet with liquids other than water at room temperature.
PAGE 3
F-01A_E1kou F-01A.book Page 22 Tuesday, September 2, 2008 6:34 PM DOCOMO does not guarantee actual operations under all states. Malfunctions deemed to be caused by inappropriate operation by the customer are not covered by the warranty. b Shake FOMA terminal approximately 20 times, firmly holding its hinge section, until there is no more water splattering.
PAGE 4
F-01A_E1kou F-01A.book Page 23 Tuesday, September 2, 2008 6:34 PM c Softly press dry, clean cloth etc., against FOMA terminal to wipe off water remaining in the microphone, earpiece, speaker, keys or hinges. e Wipe off water drained from FOMA terminal with dry, clean cloth etc. * Water, if any, remaining in FOMA terminal may ooze up after wiping off. * Do not wipe off water remaining in concaves directly with a cotton swab etc.
PAGE 5
F-01A_E1kou F-01A.book Page 24 Tuesday, September 2, 2008 6:34 PM Basic package and optional accessories F-01A (including Back Cover F33 and the written warranty) FOMA AC Adapter 01/02 (including written warranty and operation manual) Battery Pack F10 Instruction manual Man ua l * Quick Manual is appended on PXXX. CD-ROM for F-01A * The PDF version of "Manual for PC Connection" and "Kuten Code List" are contained in the CD-ROM.
PAGE 6
F-01A_E1kou F-01A.book Page 25 Tuesday, September 2, 2008 6:34 PM Before Using the Handset Names and functions of parts ............................................................................................................................................ Available FOMA terminal usage styles ............................................................................................................................. Display overview ...................................................................
PAGE 7
F-01A_E1kou F-01A.book Page 26 Tuesday, September 2, 2008 6:34 PM Names and functions of parts j a b k d l m n o p f g c q h i r s t t d i a b c d j k l e f g m n h e 26 Before Using the Handset u o a Earpiece Hear other party's voice from here. b Light sensor Sense the ambient luminance (automatic adjustment of the brightness of the display). * Blocking the light sensor may disable correct adjustment of the brightness.
PAGE 8
F-01A_E1kou F-01A.book Page 27 Tuesday, September 2, 2008 l Fingerprint sensor → P44, 118 Operation of pointing device, register/authenticate fingerprint m Infrared data port → P333, 337 Infrared communication, Infrared remote control. n FeliCa mark → P282, 333 Installation of IC card * You can use Osaifu-Keitai by placing it over IC card reader or send/receive data by iC transmission. The IC card cannot be detached. o Speaker Hear ring alert or voice of the caller using the speakerphone etc. from here.
PAGE 9
F-01A_E1kou F-01A.book Page 28 Tuesday, September 2, 2008 j CCamera key ● Start still image shooting, perform the operation shown at the upper right of the guide area. ■ Start movie recording. k aMail/▼ (scroll) key ● Display mail menu, perform the operation shown at the lower right of the guide area. ● Scroll downward the mail screen or site/website display by pages.
PAGE 10
F-01A_E1kou F-01A.book Page 29 Tuesday, September 2, 2008 6:34 PM Available FOMA terminal usage styles With this FOMA terminal, in addition to "Normal style" in which the terminal is open, you can use "Flip style" in which the display is rotated out. ･ This guide uses "Normal style" to describe operations unless especially noted. ■ Flip style You can use FOMA terminal with the display rotated out.
PAGE 11
F-01A_E1kou F-01A.book Page 30 Tuesday, September 2, 2008 6:34 PM Display overview The current state can be checked by the icon appearing on the screen.
PAGE 12
F-01A_E1kou F-01A.
PAGE 13
F-01A_E1kou F-01A.book Page 32 Tuesday, September 2, 2008 6:34 PM ◆ Task area The icon indicating the function (task) in progress appears in the task area. During Multiaccess or Multitasks, the icons show which functions are running.
PAGE 14
F-01A_E1kou F-01A.book Page 33 Tuesday, September 2, 2008 6:34 PM : Updating pattern definition/Displaying version / (gray) : Each function set or on hold ◆ Guide area Operations that can be performed by pressing m, I, g, C and a are displayed in the guide area. Displayed operations vary by the screen. Display locations and keys correspond as shown in the figure. Guide area b Pressing the keypads corresponding to the item number or pressing the keys below allows you to select an item.
PAGE 15
F-01A_E1kou F-01A.book Page 34 Tuesday, September 2, 2008 6:34 PM ･ By pressing P while watching/recording 1Seg, playing video or activating Music player or Music&Video Channel player, you can display clock. ❖ Displayed icon or state o a bcd e f g h i j kl m n Icon and date/time a b State display (e.g.
PAGE 16
F-01A_E1kou F-01A.book Page 35 Tuesday, September 2, 2008 6:34 PM ❖ Selecting functions from the menu of sub-display ❖ Displaying missed call or unread mail You can select from 7 functions : Activate/End Music player, Lock/Unlock IC card, Silent mode ON/OFF, Check new msg, Quick light, Fake call and Bluetooth ON/OFF. ･ While IC appli is activated, you cannot perform IC card Lock/Unlock.
PAGE 17
F-01A_E1kou F-01A.book Page 36 Tuesday, September 2, 2008 6:34 PM ❖ To switch the menu screen temporarily Selecting functions from menu ◆ Menu screen and switching method In each menu screen, you can temporarily switch to a different menu screen by the operations below. You can also set which menu to display when pressing m on the stand-by display.→P108 C*1 ❖ Menu screen The menu screen below is available. Kisekae menu : A menu that you can change the design using Kisekae tool.
PAGE 18
F-01A_E1kou F-01A.book Page 37 Tuesday, September 2, 2008 6:34 PM ･ Function description about the menu item at the cursor position may appear for some types or levels of the menu. The current setting may also displayed in some menu items.
PAGE 19
F-01A_E1kou F-01A.book Page 38 Tuesday, September 2, 2008 6:34 PM ◆ Selecting method of submenu When "MENU" is displayed at upper-left of the guide area, various operations can be performed with submenus. Selecting the redial submenu ■ Pulldown menu operation Move the cursor to the item to set and press g, and then press the keypads corresponding to the item number.
PAGE 20
F-01A_E1kou F-01A.book Page 39 Tuesday, September 2, 2008 6:34 PM ◆ Displaying information quickly ･ You can perform the same operations when the next icon appears. When g is pressed on the stand-by display with arrival information icon or iconcier information displayed, or with Info/calendar layout or Shortcut icons set, the display is changed to Focus mode that allows you to quickly display the related information.
PAGE 21
F-01A_E1kou F-01A.book Page 40 Tuesday, September 2, 2008 6:34 PM ･ Do not scrape with your finger or use a pointed object such as a pen on the ◆ Touch operation ･ Touch operation is enabled in the range below. Touch the display with the ball of your finger. display. Doing so may cause scratches on the display or malfunction of the sensor. ◆ Flip menu Effective area ❖ Displaying flip menu If changing style from normal to flip while stand-by display or a menu screen is displayed, flip menu appears.