User Manual
49
Before Using the Handset
F-01A_E1kou
c
With the label side of the battery pack upward, place the convex part of the
battery pack to the concave part of FOMA terminal and plug in the direction of
a
, and fit it in by pressing in the direction of
b
and close the inner lid.
d
Place the 8 tabs of back cover to the notches, press back cover in the direction of
a
to avoid forming any clearance between FOMA terminal and back cover, and
slide it in the direction of
b
to install.
e
Slide the lever of back cover in the direction of the arrow to lock.
■
Removing
a
Perform the procedure
a
-
b
of Installing.
b
Pinch the tab of battery pack and pick it up in the direction of the arrow to
remove.
✔
INFORMATION
･
Installing battery pack forcibly into FOMA terminal may damage FOMA terminal jack.
･
FOMA terminal or back cover may be damaged if you install or remove battery pack by
a method except the procedures above or if you press too hard.
･
To prevent water seepage, install back cover firmly and lock it with the lever.
･
The rubber packing of the inner lid has an important function to maintain waterproof
performance. Do not remove or damage it. Also, prevent dust from adhering to it.
Convex part
Concave part
Battery Pack
b
a
Back Cover
Lever
Tab
F-01A.book Page 49 Tuesday, September 2, 2008 6:34 PM