User Manual
Before Using the Handset
46
F-01A_E1kou
✔
INFORMATION
･
Depending on the spot or strength you tap, the alarm may not stop. And, note that
tapping too strongly may cause malfunction.
･
While walking or in the place with much vibration, operations to stop alarm sound by
double-tapping or scroll Full Browser screen by tilting FOMA terminal do not work
correctly. Also, do not walk while watching a screen. It is dangerous.
･
It may operate as double-tapping when lifting FOMA terminal with your hand.
◆
Enabling Motion sensor <Motion sensor>
1
m
[Settings & NW services]
78e1
or
2
･
Even if setting to "OFF", the Flash graphics compatible with motion sensor
operate.
Using UIM (FOMA card)
UIM (FOMA card) is a card for storing user information such as phone numbers.
･
If UIM is installed incorrectly or if there is a problem with UIM, you cannot make/
receive a call or send/receive a mail.
･
For details on handling UIM, refer to the UIM manual.
◆
Installing/Removing
･
After turning the power OFF, fold FOMA terminal and hold it with your hand.
･
Take care not to touch or scratch the IC part.
･
Installing/Removing back cover and battery pack
→
P48
■
Installing
a
Pull the tab and pull out the tray until it clicks.
b
Hold UIM with the IC side up, align the beveled corner with the tray and push into
the tray until it stops.
■
Removing
a
Perform
a
of installing operation.
b
Take out UIM.
✔
INFORMATION
･
Note that forcible installing or removing UIM, or installing battery pack with the tray
inserted at a slant may break UIM or the tray.
･
If the tray is removed, press it straight along the guide rail inside the UIM slot with UIM
left detached.
◆
Security code
Two security codes, "PIN code" and "PIN2 code", are set for UIM.
･
You can change the security codes yourself.
→
P118
IC
Corner cut
UIM
Tray
Tab
F-01A.book Page 46 Tuesday, September 2, 2008 6:34 PM