User Manual
Before Using the Handset
56
F-01A_E1kou
Caller ID notification
Notifying your phone number to the other party
You can set FOMA terminal to display your number (Caller ID) on the other party's
terminal when making a voice call, videophone call or PushTalk call.
･
For details, refer to "Mobile Phone User's Guide [Network Services]".
･
Caller ID is your important information. Carefully consider whether you want to
include caller ID information when making a call.
･
The caller ID is displayed only when the phone of the other party is a digital
mobile phone etc. enabled to display the caller ID.
･
Setting operations for this function is disabled from a location out of service area.
1
m
[Settings & NW services]
8411e1
or
2
･
Press
m
[Settings & NW services]
8412
and select "Yes" to
check the current settings.
❖
Priority of Caller ID notification
There are multiple methods to notify your phone number to the other party. If you
set or perform these methods simultaneously, the caller ID operations are
performed with the priorities below. The displayed setting and actual Notify/Not
notify may differ.
a
When setting a caller ID notification method in Call option for dialing
→
P67, 79
b
When "186" or "184" is prefixed to phone number to dial
→
P65
c
Caller ID settings of phonebook (for PushTalk, dialing 1 party)
→
P91
d
Activate/Deactivate of Caller ID notification
✔
INFORMATION
･
If an announcement of requesting caller ID is heard when making a call, make a call
again after setting your caller ID to be notified.
User information
Checking your own phone number
You can check your phone number (My phone number), Name, Mail address, etc.
1
m
[User information]
Checking during a call etc. :
s0
✔
INFORMATION
･
For details of how to check i-mode mail address, see "Mobile Phone User's Guide [i-
mode] FOMA version".
･
When 2in1 is in Dual mode, you can press
a
to switch User information between
Number A and B.
･
With 2in1 set to ON, if replacing UIM (2in1 subscriber
→
2in1 subscriber), set 2in1 to OFF
then set it to ON again to obtain the correct Number B, or obtain Number B from User
information.
→
P356
Also, if replacing UIM (2in1 subscriber
→
2in1 non-subscriber), set 2in1 to OFF to update
to the correct user information.
→
P391
F-01A.book Page 56 Tuesday, September 2, 2008 6:34 PM