User Manual

Before Using the Handset
54
F-01A_E1kou
◆ Operations to perform after turning the power ON at the
first time
When turning the power ON for the first time, operate in the order of
"AdvancedMode setting"
→ "Initial setting". The settings made can be changed later.
･ When initialization is finished, a confirmation screen of software update function
appears. Press
g to display the stand-by screen.
❖ AdvancedMode setting
1
"Yes" or "No" on the confirmation screen
･ When selecting "Yes", "AdvancedMode" of Kisekae Tool is set.
If you cancel the confirmation screen by pressing
c or f , the
confirmation screen reappears when the power is turned ON the next time.
❖ Default setting
･ Always set Password and Request permit/deny. When C or c , f is
pressed before setting terminal security code or Request permit/deny, a
confirmation screen appears asking you to exit. If you exit by selecting "Yes", this
confirmation screen reappears when the power is turned ON the next time.
1
Set the required items on Initial setting screen eC
Date & time : Set the date and time. → P55
Password : Change the terminal security code after performing authentication.
→ P117
Fingerprint : After performing authentication, register a fingerprint to be used
for authentication.
→ P120
Keypad sound : Set a confirmation sound emitted when a key is pressed. → P100
Text size : Set size of characters for phonebook, mail, etc. → P113
Request permit/deny : After performing authentication, set if you provide
location information. To permit the location request in a specified period, set
the permission period in Request permit/deny.
→ P301
❖ Checking Welcome mail
"Welcome デコメアニメ (Decome-Anime) " mail is saved by default.
appears on the stand-by display. If FOMA terminal is folded, the light (blinking) and
mail light indicate that there is unread mail.
1
geg
The next procedures → P156 Step 2 and the following steps in "Displaying mail
in Inbox/Outbox"
✔ INFORMATION
･ When turning FOMA terminal ON, do not touch the fingerprint sensor with fingers
before the stand-by display appears.
･ When UIM is replaced, authentication is required after turning ON FOMA terminal.
When authentication has succeeded, the stand-by display appears. If an incorrect
terminal security code is entered 5 times consecutively or if authentication has failed 5
times consecutively when Fingerprint access is "ON", the power is automatically turned
OFF (the power can be turned ON again).
･ If no operation is performed with something displayed on the screen, the display light
is turned off automatically according to the settings in Light time-out or Power saving
mode. It also applies while making a call. The display light turns on again if there is any
operation or incoming call.
F-01A.book Page 54 Tuesday, September 2, 2008 6:34 PM